Juniper ACX1000 Configuration Manual page 1286

ACX Series Universal Access Router Configuration Guide
Table 102: jjnxSoamPmNotifications Table
Object
jnxSoamLmSessionStartStopAlarm
1228
Object ID
jnxSoamPmNotifications 1
Description
A jnxSoamLmSessionStartStopAlarm
notification is sent when the state of
jnxSoamLmCfgSessionStatus changes.
The management entity that receives the
notification can identify the system from
the network source address of the
notification, and can identify the
individual PM session reporting the
start/stop by the indices in the OID
jnxSoamLmCfgSessionStatus, including
dot1agCfmMdIndex, dot1agCfmMaIndex,
dot1agCfmMepIdentifier, and
jnxSoamLmCfgIndex.
An agent is not to generate more than
one jnxSoamLmSessionStartStopAlarm
'notification-event' in a given time interval
per LM session as specified by the
jnxSoamPmNotificationCfgAlarmInterval.
A 'notification-event' is the transmission
of a single notification to a list of
notification destinations.
If additional operational state changes
occur within the
jnxSoamPmNotificationCfgAlarmInterval
period, then notification generation for
these changes are be suppressed by the
agent until the current alarm interval
expires. At the end of an alarm interval
period, one notification-event is
generated if any operational state
changes occurred since the start of the
alarm interval period. In such a case,
another alarm interval period is started
right away.
Copyright © 2017, Juniper Networks, Inc.