Series Routers - Juniper ACX1000 Configuration Manual

ACX Series Universal Access Router Configuration Guide
Table 81: Firewall Filter Match Conditions for VPLS Traffic (continued)
Match Condition
loss-priority level
loss-priority-except level
port number
port-except number
prefix-list name
prefix-list name except
source-mac-address address
source-port number
source-port-except number
1078
Description
Packet loss priority (PLP) level. Specify a single level or multiple levels:
, or .
medium-high high
Supported on M120 and M320 routers; M7i and M10i routers with the Enhanced CFEB (CFEB-E);
and MX Series routers.
For IP traffic on M320, MX Series, and T Series routers with Enhanced II Flexible PIC Concentrators
(FPCs) and EX Series switches, you must include the
class-of-service] hierarchy level to commit a PLP configuration with any of the four levels specified.
If the tri-color statement is not enabled, you can only configure the
applies to all protocol families.
For information about the
tri-color
to set the PLP level of incoming packets, see Understanding How Forwarding Classes Assign
Classes to Output Queues.
Do not match on the packet loss priority level. Specify a single level or multiple levels:
, , or
medium-low medium-high
For information about using behavior aggregate (BA) classifiers to set the PLP level of incoming
packets, see "Understanding How Behavior Aggregate Classifiers Prioritize Trusted Traffic" on
page 950.
(MX Series routers and EX Series switches only) TCP or UDP source or destination port. You
cannot specify both the port match condition and either the
condition in the same term.
(MX Series routers and EX Series switches only) Do not match on the TCP or UDP source or
destination port. You cannot specify both the
or source-port match condition in the same term.
(MX Series routers and EX Series switches only) Match the destination or source prefixes in the
specified list. Specify the name of a prefix list defined at the
] hierarchy level.
prefix-list-name
NOTE: VPLS prefix lists support only IPV4 addresses. IPV6 addresses included in a VPLS prefix
list will be discarded.
(MX Series routers and EX Series switches only) Do not match the destination or source prefixes
in the specified list. For more information, see the
Source MAC address of a VPLS packet.
(MX Series routers and EX Series switches only) TCP or UDP source port field. You cannot specify
the port and source-port match conditions in the same term.
(MX Series routers and EX Series switches only) Do not match on the TCP or UDP source port
field. You cannot specify the port
tri-color
statement and about using behavior aggregate (BA) classifiers
.
high
destination-port
port match condition and either the
destination-prefix-list
and source-port match conditions in the same term.
, ,
low medium-low
statement at the
[edit
high and low levels. This
low ,
or source-port match
destination-port
[edit policy-options prefix-list
match condition.
Copyright © 2017, Juniper Networks, Inc.