Juniper ACX1000 Configuration Manual page 1439

Copyright © 2017, Juniper Networks, Inc.
user@host# set vlan-tagging
Configure a logical unit for the interface.
4.
[edit interfaces ge-0/0/4]
user@host# edit unit 0
Specify the encapsulation for Ethernet VLAN circuits.
5.
[edit interfaces ge-0/0/4 unit 0]
user@host# set encapsulation vlan-ccc
Configure the VLAN ID as 101 on the logical interface.
6.
[edit interfaces ge-0/0/4 unit 0]
user@host# set vlan-id 101
Go to the top level of the configuration command mode.
7.
[edit interfaces ge-0/0/4 unit 0]
user@host# top
In configuration mode, go to the
8.
[edit]
user@host# edit services
Configure a real-time performance monitoring service (RPM) instance.
9.
[edit services]
user@host# edit rpm
Configure an RFC 2544-based benchmarking test for the RPM instance.
10.
[edit services rpm]
user@host# edit rfc2544-benchmarking
Define a name for the test—for example, test1. The test name identifier can be up
11.
to 32 characters in length.
[edit services rpm rfc2544-benchmarking]
user@host# edit tests test-name test1
Specify the logical interface on which the RFC 2544-based benchmarking test is
12.
run.
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set test-interface ge-0/0/4.1
Specify reflect as the test mode for the packets that are sent during the
13.
benchmarking test.
[edit services rpm rfc2544-benchmarking tests test-name test1]
Chapter 37: Configuring RFC 2544-Based Benchmarking Tests
hierarchy level.
[edit services]
1381