Juniper ACX1000 Configuration Manual page 1375

Results
Device PE1
Copyright © 2017, Juniper Networks, Inc.
On the MTU device interfaces that connect to other PE devices, configure an interior
gateway protocol (IGP), such as OSPF or IS-IS.
[edit protocols isis]
user@PE2# set level 1 disable
user@PE2# set interface ge-2/0/10.0
user@PE2# set interface lo0.0
Configure VPLS.
4.
The
neighbor 10.255.14.217
address.
The VPLS ID must match the virtual circuit ID that is configured on the MTU (Device
PE1).
[edit routing-instances customer]
user@PE2# set instance-type vpls
user@PE2# set interface ge-2/0/6.601
user@PE2# set protocols vpls vpls-id 601
user@PE2# set protocols vpls neighbor 10.255.14.217 encapsulation-type
ethernet-vlan
Configure the router ID.
5.
[edit routing-options]
user@PE2# set router-id 10.255.14.216
From configuration mode, confirm your configuration by entering the
,
show protocols show routing-instances
output does not display the intended configuration, repeat the instructions in this example
to correct the configuration.
user@PE1# show interfaces
ge-2/0/5 {
vlan-tagging;
encapsulation vlan-ccc;
unit 601 {
encapsulation vlan-ccc;
vlan-id 601;
output-vlan-map swap;
family ccc;
}
}
ge-2/0/10 {
unit 0 {
family inet {
address 192.0.2.2/24;
}
family iso;
family mpls;
}
}
ge-2/0/11 {
Chapter 35: Configuring Virtual Private LAN Service
statement points to Device PE1's loopback interface
, and
show routing-options
,
show interfaces
commands. If the
1317