Juniper ACX1000 Configuration Manual page 1343

Copyright © 2017, Juniper Networks, Inc.
configure the logical interface by including the
option.
ccc
[edit interfaces]
ge-2/0/5 {
encapsulation ethernet-ccc;
unit 0 {
family ccc;
}
}
On Router PE1, configure the Layer 2 circuit by including the
2.
specifying the IP address of Router PE3 as the neighbor. Configure the Gigabit
Ethernet logical interface by including the
as the ID. Also configure a backup neighbor for the Layer 2 circuit by including
100
the
backup-neighbor
Router PE4 as the backup neighbor, and including the
[edit protocols]
l2circuit {
neighbor 192.0.2.3 {
interface ge-2/0/5.0 {
virtual-circuit-id 100;
backup-neighbor 192.0.2.4 { # Backup H-VPLS PE router
standby;
}
}
}
On Router PE2, configure the Gigabit Ethernet interface connected to Router CE2.
3.
Include the encapsulation
configure the logical interface by including the
option.
ccc
[edit interfaces]
ge-2/0/6 {
encapsulation ethernet-ccc;
unit 0 {
family ccc;
}
}
On Router PE2, configure the Layer 2 circuit by including the
4.
and specifying the IP address of Router PE3 as the neighbor. Configure the Gigabit
Ethernet logical interface by including the
as the ID. Configure the encapsulation by including the
200
statement and specifying the
the Layer 2 circuit by including the
loopback interface IP address of Router PE4 as the backup neighbor, and including
the statement.
standby
[edit protocols]
l2circuit {
Chapter 35: Configuring Virtual Private LAN Service
family
virtual-circuit-id
statement, specifying the loopback interface IP address of
statement and specify the
family
virtual-circuit-id
ethernet option. Also configure a backup neighbor for
backup-neighbor
statement and specifying the
statement and
neighbor
statement and specifying
statement.
standby
ethernet-ccc option. Also
statement and specifying the
statement
neighbor
statement and specifying
encapsulation-type
statement, specifying the
1285