Inet6-Vpn - Juniper ACX1000 Configuration Manual

ACX Series Universal Access Router Configuration Guide

inet6-vpn

Syntax
Hierarchy Level
Release Information
Description
Options
Required Privilege
Level
Related
Documentation
1564
inet6-vpn (any | multicast | unicast) {
aggregate-label;
prefix-limit maximum;
rib-group rib-group-name;
}
[edit logical-systems logical-system-name protocols bgp family],
[edit logical-systems logical-system-name protocols bgp group group-name family],
[edit protocols bgp family],
[edit protocols bgp group group-name family]
Statement introduced before Junos OS Release 7.4.
Statement introduced in Junos OS Release 11.3 for QFX Series switches.
Enable IP version 6 (IPv6) on the provider edge (PE) router for the Layer 3 VPN.
NOTE: The
[edit logical-systems]
Series routers.
—Configure the family type to be both multicast and unicast.
any
multicast —Configure the family type to be multicast. This means that the BGP peers are
being used only to carry the unicast routes that are being used by multicast for
resolving the multicast routes.
—Maximum prefix limit.
prefix-limit maximum
Range: 1 through 4,294,967,295
Default: 1
rib-group rib-group-name —The name of the routing table group.
—Configure the family type to be unicast. This means that the BGP peers only
unicast
carry the unicast routes that are being used for unicast forwarding purposes.
routing—To view this statement in the configuration.
routing-control—To add this statement to the configuration.
Configuring Layer 3 VPNs to Carry IPv6 Traffic on page 844
Junos OS Routing Protocols Library
hierarchy level is not applicable in ACX
Copyright © 2017, Juniper Networks, Inc.