Managed Objects For Jnxsoamdmcfgtable - Juniper ACX1000 Configuration Manual

Table 94: jnxSoamLmHistoryStatsTable (continued)
Object
jnxSoamLmHistoryStatsBackwardMinFlr
jnxSoamLmHistoryStatsBackwardMaxFlr
jnxSoamLmHistoryStatsBackwardAvgFlr
jnxSoamLmHistoryStatsSoamPdusSent
jnxSoamLmHistoryStatsSoamPdusReceived

Managed Objects for jnxSoamDmCfgTable

Copyright © 2017, Juniper Networks, Inc.
Chapter 34: Configuring Operations, Administration, and Management (OAM)
Object ID
jnxSoamLmHistoryStatsEntry 12
jnxSoamLmHistoryStatsEntry 13
jnxSoamLmHistoryStatsEntry 14
jnxSoamLmHistoryStatsEntry 15
jnxSoamLmHistoryStatsEntry 16
The , whose object identifier is
jnxSoamDmCfgTable
the that signifies the Ethernet loss measurement (ETH-DM)
jnxSoamDmCfgEntry
configuration settings. Each
, contains the objects listed in the following table.
{jnxSoamDmCfgTable 1}
The jnxSoamDmCfgTable includes configuration objects and operations for the Delay
Measurement function. Each row in the table represents a Delay Measurement session
Description
Contains the minimum one-way frame
loss ratio in the backward direction
calculated by this MEP for this
Measurement Interval. The FLR value is
a ratio that is expressed as a percent with
a value of 0 (ratio 0.00) through 100000
(ratio 1.00). Units are in milli-percent,
where 1 indicates 0.001 percent.
Contains the maximum one-way frame
loss ratio in the backward direction
calculated by this MEP for this
Measurement Interval. The FLR value is
a ratio that is expressed as a percent with
a value of 0 (ratio 0.00) through 100000
(ratio 1.00). Units are in milli-percent,
where 1 indicates 0.001 percent.
Contains the average one-way frame loss
ratio in the backward direction calculated
by this MEP for this Measurement
Interval. The FLR value is a ratio that is
expressed as a percent with a value of 0
(ratio 0.00) through 100000 (ratio 1.00).
Units are in milli-percent, where 1
indicates 0.001 percent.
Contains the count of the number of
SOAM PDUs sent during this
Measurement Interval. This object applies
when jnxSoamLmCfgType is lmLmm,
lmSlm, or lmCcm. It indicates the number
of LMM, CCM, or SLM SOAM frames
transmitted.
Contains the count of the number of
SOAM PDUs received in this
Measurement Interval. This object applies
when jnxSoamLmCfgType is lmLmm,
lmSlm, or lmCcm. This object indicates
the number of LMR, CCM, or SLR SOAM
frames received.
{jnxSoamPmLmObjects 1}
jnxSoamDmCfgEntry , whose object identifier is
, contains
1191