Starting An On-Demand Eth-Slm Session - Juniper ACX1000 Configuration Manual

ACX Series Universal Access Router Configuration Guide
Related
Documentation

Starting an On-Demand ETH-SLM Session

1156
(Optional) Set the iteration count, which indicates the number of iterations for which
5.
this connection should partake in the iterator for acquiring SLA measurements, with
a value from 1 through 65,535. The default value is 0 (that is, infinite iterations).
[edit protocols oam ethernet connectivity-fault-management maintenance-domain
md-name maintenance-association ma-name mep mep-id remote-mep remote-mep-id
sla-iterator-profile profile-name]
user@host# set iteration-count count-value
(Optional) Set the priority, which is the
6.
frames, with a value from 0 through 7. The default value is 0.
[edit protocols oam ethernet connectivity-fault-management maintenance-domain
md-name maintenance-association ma-name mep mep-id remote-mep remote-mep-id
sla-iterator-profile profile-name]
user@host# set priority priority-value
Verify the configuration.
7.
[edit protocols oam ethernet connectivity-fault-management maintenance-domain
md-name maintenance-association ma-name mep mep-id remote-mep
remote-mep-id]
user@host# show
sla-iterator-profile profile-name {
data-tlv-size size;
iteration-count count-value;
priority priority-value;
}
Ethernet Synthetic Loss Measurement Overview on page 1140
Transmission of ETH-SLM Messages on page 1141
Format of ETH-SLM Messages on page 1144
Guidelines for Configuring ETH-SLM on page 1146
Scenarios for Configuration of ETH-SLM on page 1147
Managing ETH-SLM Statistics and ETH-SLM Frame Counts on page 1148
Starting an On-Demand ETH-SLM Session on page 1156
Troubleshooting Failures with ETH-SLM
Ethernet Interfaces Feature Guide for Routing Devices
To start an on-demand Ethernet synthetic loss measurement (ETH-SLM) session, type
the
monitor ethernet synthetic-loss-measurement one-way
mode, and specify the peer MEP by its MAC address or by its MEP identifier.
For example:
value that is sent in the Y.1731 data
vlan-pcp
command in operational
Copyright © 2017, Juniper Networks, Inc.