Restart Chassis-Control - Juniper ACX1000 Configuration Manual

ACX Series Universal Access Router Configuration Guide

restart chassis-control

List of Syntax
Syntax
Syntax (MX Series
Routers)
Syntax (PTX Series)
Release Information
Description
Options
1800
Syntax on page 1800
Syntax (MX Series Routers) on page 1800
Syntax (PTX Series) on page 1800
restart chassis-control
<lcc number | sfc number>
<gracefully | immediately | soft>
restart chassis-control
<gracefully | immediately | soft>
restart chassis-control
<gracefully | immediately | soft>
Command introduced before JUNOS Release 7.4.
Command introduced in Junos OS Release 12.3 for MX2020 3D Universal Edge Routers.
Command introduced in Junos OS Release 12.3 for MX2010 3D Universal Edge Routers.
Command introduced in Junos OS Release 17.2 for MX2008 3D Universal Edge Routers.
Command introduced in Junos OS Release 17.3 for MX10003 3D Universal Edge Routers.
Restart the chassis management process.
NOTE: When GRES is configured and the
is executed on a TX Matrix Plus router with 3D SIBs, we cannot ascertain
which Routing Engine becomes a master. This is due to the chassisd restart.
The chassis process or chassid is responsible for maintaining and retaining
mastership and when it is restarted, the new chassisd is processed based on
the router load. This results in one of the Routing Engines being made master.
lcc number—(Routing matrix only) (Optional) Restart the software process for a specific
T640 routing node that is connected to a TX Matrix platform. Replace
a value from through
0
sfc number—(TX Matrix Plus routers only) (Optional) Restart the software process on
the TX Matrix Plus router (or switch-fabric chassis). Replace
gracefully—(Optional) Restart the software process.
immediately—(Optional) Immediately restart the software process.
restart chassis-control
.
3
command
number
number with 0 .
Copyright © 2017, Juniper Networks, Inc.
with