Example: Configuring Fixed Classification On An Atm Ima Pseudowire - Juniper ACX1000 Configuration Manual

ACX Series Universal Access Router Configuration Guide
Related
Documentation

Example: Configuring Fixed Classification on an ATM IMA Pseudowire

Requirements
Overview
898
Apply the forwarding class to the logical interface:
6.
[edit class-of-service interfaces at-fpc/pic/port unit logical-unit-number]
user@host# set forwarding-class class-name
After you have configured fixed classification, enter the
mode.
Understanding CoS on ATM IMA Pseudowire Interfaces Overview on page 895
Example: Configuring Fixed Classification on an ATM IMA Pseudowire on page 898
Configuring Policing on an ATM IMA Pseudowire on page 912
Configuring Shaping on an ATM IMA Pseudowire on page 901
This example shows the configuration of fixed classification on an ATM IMA pseudowire.
Fixed classification is configured on the logical interface (unit) of the ATM IMA pseudowire.
The software assigns the fixed classification to packets on the basis of the fixed
classification parameters associated with the logical interface on which the ATM cells
are received.
NOTE: This example is not applicable on ACX5048 and ACX5096 routers.
Requirements on page 898
Overview on page 898
Configuration on page 899
This example uses the following hardware and software components:
ACX Series router
Junos OS Release 12.2 or later
A previously configured ATM IMA pseudowire. For steps to configure an ATM IMA
pseudowire, see "Configuring Inverse Multiplexing for ATM (IMA)" on page
In this example, the configured forwarding class
the ingress logical interface
on the logical interface unit zero (0) to
commit
is applied to all packets received on
fc-1
. The fixed classification classifies all traffic
at-0/0/16 unit 0
queue-num 1 .
command in configuration
185.
Copyright © 2017, Juniper Networks, Inc.