Managed Objects For Jnxsoamdmmeasuredstatstable - Juniper ACX1000 Configuration Manual

Table 95: jnxSoamDmCfgTable (continued)
Object
j n xSoamDmC fgInterFr ameDelayV ari a ti o nSel ecti o nOffset
jnxSoamDmCfgSessionType
jnxSoamDmCfgSessionStatus
jnxSoamDmCfgHistoryClear
jnxSoamDmCfgRowStatus

Managed Objects for jnxSoamDmMeasuredStatsTable

Copyright © 2017, Juniper Networks, Inc.
Chapter 34: Configuring Operations, Administration, and Management (OAM)
Object ID
jnxSoamDmCfgEntry 18
jnxSoamDmCfgEntry 19
jnxSoamDmCfgEntry 20
jnxSoamDmCfgEntry 21
jnxSoamDmCfgEntry 22
The
jnxSoamDmMeasuredStatsTable
, contains the
2} jnxSoamDmMeasuredStatsEntry
measurement (ETH-DM) statistical details. Each
object identifier is
{jnxSoamDmMeasuredStatsTable 1}
following table.
Description
Specifies the selection offset for Inter-Frame
Delay Variation measurements. If this value
is set to n, then the IFDV is calculated by
taking the difference in frame delay between
frame F and frame (F+n). This object can
only be written at row creation time and
cannot be modified once it has been created.
Indicates whether the current session is
defined to be 'Proactive' or 'On-Demand'. A
value of 'proactive' indicates the current
session is 'Proactive'. A value of 'onDemand'
indicates the current session is
'On-Demand'. This object can only be
written at row creation time and cannot be
modified once it has been created.
indicates the current status of the LM
session. A value of 'active' indicates the
current DM session is active, i.e. the current
time lies between the start time and the stop
time, and jnxSoamDmCfgEnabled is true. A
value of 'notActive' indicates the current DM
session is not active, i.e. it has not started
yet, has stopped upon reaching the stop
time, or is disabled.
Clears the Delay Measurement history Table
(jnxSoamDmHistoryStatsTable) - all rows
are deleted. When read the value always
returns 'false'. Writing this value does not
change the current stat table, nor any of the
items in the configuration table. Writing this
value during row creation has no effect.
Specifies the status of the row. The writable
columns in a row cannot be changed if the
row is active, except for
jnxSoamDmCfgHistoryClear and
jnxSoamDmCfgEnabled objects. All columns
must have a valid value before a row can be
activated.
, whose object identifier is
that signifies the Ethernet delay
jnxSoamDmMeasuredStatsEntry
, contains the objects listed in the
{jnxSoamPmDmObjects
, whose
1205