Juniper ACX1000 Configuration Manual page 1580

ACX Series Universal Access Router Configuration Guide
Required Privilege
Level
1522
(MX Series, M120, and M320 routers only)—Include the packet's IP payload in
payload
the hash key.
ip (MX Series, M120, and M320 routers only)—Include the IP address of the IPv4 or IPv6
payload in the hash key.
(MX Series routers only)—Use this to include Layer 3 information from the
layer-3
packet's IP payload in the hash key.
destination-ip-only (MX Series routers only)—Use this to include only the destination
IP address in the payload in the hash key.
(MX Series routers only)—Use this to include only the source IP
source-ip-only
address in the payload in the hash key.
NOTE: You can include either the
statement, not both. They are mutually exclusive.
layer-3-only (M120, and M320 routers only)—Include only the Layer 3 information
from the packet's IP payload in the hash key.
(MX Series routers only)—Include Layer 4 information from the packet's IP
layer-4
payload in the hash key.
NOTE: On MX Series routers only, you can configure either Layer 3 or Layer
4 load balancing, or both at the same time.
NOTE: On I chip platforms, an unknown Layer 4 header is excluded from
load-balance hashing to avoid undesired packet reordering.
source-mac —Include the source-address MAC information in the hash key.
(MX Series routers only)—Configure the symmetric hash or symmetric
symmetric-hash
hash complement for configuring symmetrical load balancing on an 802.3ad Link
Aggregation Group.
—Include the complement of the symmetric hash in the hash key.
complement
interface—To view this statement in the configuration.
interface-control—To add this statement to the configuration.
source-ip-only or the destination-ip-only
Copyright © 2017, Juniper Networks, Inc.