Guidelines For Applying Service Filters; Restrictions For Inline Services Interfaces; Statement Hierarchy For Applying Service Filters - Juniper ACX1000 Configuration Manual

ACX Series Universal Access Router Configuration Guide

Guidelines for Applying Service Filters

Restrictions for Inline Services Interfaces

Statement Hierarchy for Applying Service Filters

1036
Network Address Translation Rules Overview on page 1004
Configuring Service Sets for Network Address Translation on page 1030
Configuring Service Sets to Be Applied to Services Interfaces on page 1031
Configuring Queuing and Scheduling on Inline Services Interface on page 1040
This topic covers the following information:
Restrictions for Inline Services Interfaces on page 1036
Statement Hierarchy for Applying Service Filters on page 1036
Associating Service Rules with Inline Services Interfaces on page 1037
Filtering Traffic Before Accepting Packets for Service Processing on page 1037
You can apply a service filter to IPv4 traffic associated with a service set at an inline
services interface only.
ACX Series routers do not support post-service filters.
You can enable packet filtering of IPv4 traffic before a packet is accepted for input service
processing. To do this, apply a service filter to the inline services interface input in
conjunction with an interface service set.
The following configuration shows the hierarchy levels at which you can apply the service
filters to inline services interfaces:
[edit]
interfaces {
interface-name {
unit unit-number {
family (inet | inet6) {
service {
input {
service-set service-set-name
}
output {
[ service-set service-set-name
}
}
}
}
}
}
service-filter service-filter-name;
<service-filter filter-name> ];
Copyright © 2017, Juniper Networks, Inc.