Juniper ACX1000 Configuration Manual page 1289

Table 102: jjnxSoamPmNotifications Table (continued)
Object
Copyright © 2017, Juniper Networks, Inc.
Chapter 34: Configuring Operations, Administration, and Management (OAM)
Object ID Description
"An jnxSoamPmThresholdCrossingAlarm
notification is sent if the following
conditions are met for a particular type.
For an aboveAlarm, the following five
conditions must be satisfied:
1. Measurement of the parameter is
enabled via
jnxSoamLmCfgMeasurementEnable
for a LM crossing or
jnxSoamDmCfgMeasurementEnable
for a DM crossing.
2. The parameter threshold is configured
in the jnxSoamLmThresholdCfgTable
or jnxSoamDmThresholdCfgTable;
and c) the threshold crossing type of
bPmThresholdAboveAlarm is
enabled.
3. The measured value of the parameter
exceeds the value configured in the
jnxSoamLmThresholdCfgTable for a
LM crossing entry or
jnxSoamDmThresholdCfgTable for a
DM crossing entry for a type of
bPmThresholdAboveAlarm.
4. No previous
jnxSoamPmThresholdCrossingAlarm
notifications with type aboveAlarm
have been sent relating to the same
threshold in the
jnxSoamLmThresholdCfgTable or
jnxSoamDmThresholdCfgTable and
the same parameter, during this
Measurement Interval.
For a setAlarm, the following five
conditions must be met:
1. Measurement of the parameter is
enabled using
jnxSoamLmCfgMeasurementEnable
for a LM crossing or
jnxSoamDmCfgMeasurementEnable
for a DM crossing.
2. The parameter threshold is configured
in the jnxSoamLmThresholdCfgTable
or jnxSoamDmThresholdCfgTable.
3. The threshold crossing type of
bPmThresholdSetClearAlarm is
enabled.
4. The measured value of the parameter
exceeds the value configured in the
jnxSoamLmThresholdCfgTable for a
LM crossing entry or
jnxSoamDmThresholdCfgTable for a
1231