Table of Contents
Advertisement
172 Commissioning
7.8.4.3.8 "Tasks" > "Task n" Submenu
In this submenu, information on the selected task is displayed.
The submenu only appears when CODESYS 2 is enabled as the runtime system.
Table 125: "PLC Runtime" > "Information" > "Tasks" > "Task n" Submenu
Parameters
Cycle count
Cycle time (µsec)
Cycle time min (µsec)
Cycle time max (µsec)
Cycle time avg (µsec)
Status
Mode
Priority
Interval (msec)
To return to the higher-level menu, press [Q] or [Return].
7.8.4.3.9 "PLC Runtime" > "General Configuration" Submenu
This submenu contains other submenus with general settings for the runtime
system.
Table 126: "PLC Runtime" > "General Configuration" Submenu
Menu Item
0. Back to ...
1. PLC Runtime Version
2. Home Dir On SD Card
To make a selection, choose the appropriate menu item.
To return to the higher-level menu, press [Q].
Manual
Draft version 1.2.1 from 2017-09-13, valid from FW Version 02.06.20(09)
750-8207 PFC200 CS 2ETH RS 3G
Explanation
Number of task cycles since the system start
Currently measured task cycle time for the task
Minimum task cycle time for the task since the
system start
Maximum task cycle time for the task since the
system start
Average task cycle time since the system start
Task status (e.g., RUN, STOP)
Task execution mode (e.g., in cycles)
Set task priority
Set task interval
Explanation
Back to the higher-level menu
Opens a submenu for the CODESYS runtime
system settings
Opens a submenu for the home directory settings
WAGO-I/O-SYSTEM 750
Advertisement
Chapters
Table of Contents
Troubleshooting
