Set Service-Profile Cos - 3Com WX4400 Command Reference Manual

set service-profile
cos
Examples — The following command configures service profile sp2 to
use 104-bit WEP encryption:
WX4400# set service-profile sp2 cipher-wep104 enable
success: change accepted.
See Also
display service-profile on page 330
set service-profile cipher-ccmp on page 399
set service-profile cipher-tkip on page 400
set service-profile cipher-wep40 on page 401
set service-profile wep key-index on page 432
set service-profile wpa-ie on page 433
Sets the Class-of-Service (CoS) level for static CoS.
Syntax — set service-profile name cos level
name — Service profile name.
level — CoS value assigned by the MAP to all traffic in the service
profile.
Defaults — The default static CoS level is 0.
Access — Enabled.
History —Introduced in MSS Version 4.2.
Usage — This command applies only when static CoS is enabled. If static
CoS is disabled, prioritization is based on the QoS mode configured in the
radio profile, and on any ACLs that set CoS. (See the "Configuring
Quality of Service" chapter of the
Configuration Guide.) To enable static CoS, use the set service-profile
static-cos command.
Examples — The following command changes the static CoS level to 7
(voice priority):
WX4400# set service-profile sp1 cos 7
success: change accepted.

set service-profile cos

Wireless LAN Switch and Controller
403