Display Ip Telnet - 3Com WX4400 Command Reference Manual

152 C 7: IP S
HAPTER

display ip telnet

C
ERVICES OMMANDS
Table 36 Output of display ip route (continued)
Field
NH-Type
Gateway
VLAN:Interface
See Also
clear ip route on page 134
display interface on page 146
display vlan config on page 115
set interface on page 164
set ip route on page 171
Shows information about the Telnet management port.
Syntax — display ip telnet
Defaults — None.
Access — All.
History —Introduced in MSS Version 3.0.
Description
Next-hop type:
Local — Route is for a local interface. MSS adds the route
when you configure an IP address on the WX switch.
Direct — Route is for a locally attached subnet. MSS adds
the route when you add an interface in the same subnet to
the WX switch.
Router — Route is for a remote destination. A WX switch
forwards traffic for the destination to the gateway router.
Next-hop router for reaching the route destination.
This field applies only to static routes.
Destination VLAN, protocol type, and IP address of the route.
Because direct routes are for local interfaces, a destination IP
address is not listed.
The destination for the IP multicast route is MULTICAST.
For static routes, the value Down means the WX switch does not
have an interface to the destination's next-hop router. To
provide an interface, configure an IP interface that is in the same
IP subnet as the next-hop router. The IP interface must be on a
VLAN containing the port that is attached to the gateway
router.