Display Fdb; Set Vlan Port - 3Com WX4400 Command Reference Manual

106 C 5: VLAN C
HAPTER

display fdb

OMMANDS
The following command completely removes VLAN marigold:
WX4400# clear vlan marigold
This may disrupt user connectivity.
Do you wish to continue? (y/n) [n]y
success: change accepted.
See Also
set vlan port on page 121
display vlan config on page 115
Displays entries in the forwarding database.
Syntax — display fdb
display fdb {perm | static | dynamic | system | all} [port
port-list | vlan vlan-id]
mac-addr-glob
Specify a MAC address, or use the wildcard character (*) to specify a
set of MAC addresses. (For details, see "MAC Address Globs" on
page 29.)
vlan vlan-id
entries.
perm — Displays permanent entries. A permanent entry does not age
out and remains in the database even after a reboot, reset, or power
cycle.
static — Displays static entries. A static entry does not age out, but
is removed from the database after a reboot, reset, or power cycle.
dynamic — Displays dynamic entries. A dynamic entry is automatically
removed through aging or after a reboot, reset, or power cycle.
system — Displays system entries. A system entry is added by MSS.
For example, the authentication protocols can add entries for wired
and wireless authentication users.
all — Displays all entries in the database, or all the entries that match
a particular port or ports or a particular VLAN.
port port-list — Destination port(s) for which to display entries.
Defaults — None.
[mac-addr-glob
— A single MAC address or set of MAC addresses.
— Name or number of a VLAN for which to display
[vlan vlan-id ]]