3Com WX4400 Command Reference Manual page 154

154 C 7: IP S
HAPTER ERVICES
C
OMMANDS
Examples — To display NTP information for a WX switch, type the
following command:
WX4400> display ntp
NTP client: enabled
Current update-interval: 20(secs)
Current time: Fri Feb 06 2004, 12:02:57
Timezone is set to 'PST', offset from UTC is -8:0 hours.
Summertime is enabled.
Last NTP update: Fri Feb 06 2004, 12:02:46
NTP Server
---------------------------------------------------
192.168.1.5
Table 38 describes the fields in this display.
Table 38 Output for display ntp
Field
NTP client
Current update-interval Number of seconds between queries sent by the WX
Current time
Timezone
Summertime
Last NTP update
NTP Server
Peer state
SYSPEER
Description
State of the NTP client. The state can be one of the
following:
Enabled
Disabled
switch to the NTP servers for updates.
System time that was current on the WX switch when you
pressed Enter after typing the display ntp command.
Time zone configured on the WX switch. MSS offsets the
time reported by the NTP server based on the time zone.
This field is displayed only if you change the time zone.
Summertime period configured on the WX switch. MSS
offsets the system time +1 hour and returns it to standard
time for daylight savings time or a similar summertime
period that you set.
This field is displayed only if you enable summertime.
Time when the WX switch received the most recent
update from an NTP server.
IP address of the NTP server.
Local State
SYNCED