Display Dap Boot-Configuration - 3Com WX4400 Command Reference Manual

display dap
boot-configuration
Displays information about the static IP address configuration (if any) on a
Distributed MAP.
Syntax —
display dap boot-configuration dap-num
— Number of a Distributed MAP for which to display static IP
dap-num
configuration information.
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 4.2.
Examples — The following command displays static IP configuration
information for Distributed MAP 1:
WX1200# display dap boot-configuration 1
Flags: 0
DAP: 1
Enable ip:
Enable vlan:
Enable wx:
Vlan Tag:
IP address:
gateway:
WX IP:
Table 59 describes the fields in this display.
Table 59 Output for show dap boot-configuration
Field Description
Flags
DAP Distributed MAP number.
Enable ip Whether static IP address assignment is enabled for this
Distributed MAP.
Enable vlan Whether the Distributed MAP is configured to use a VLAN tag.
Enable wx Whether the Distributed MAP is configured to use a manually
specified WX switch as its boot device.
Vlan Tag The VLAN tag that the Distributed MAP is configured to use (if
any).

display dap boot-configuration

no
no
no
off
0.0.0.0 IP netmask:
0.0.0.0
0.0.0.0 DNS:
321
0.0.0.0
0.0.0.0