3Com WX4400 Command Reference Manual page 672

672 C 24: B
HAPTER OOT
boot> boot FN=WXA03001.Rel DEV=boot1
Compact Flash load from boot0:WXA03001.Rel.
unzip: Inflating ramdisk_3.0.1_092304_WX4400 OK
unzip file len 36196930 OK
Copyright (c) 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004
The NetBSD Foundation, Inc.
Copyright (c) 1982, 1986, 1989, 1991, 1993
The Regents of the University of California.
Detecting hardware...done.
readclock: 2004-9-29 21:45:7.31 UTC
system initialized (3.0.1), starting MSS
Executing update_3
Starting supervisor 3.0.1_092304_WX4400 ...
SNMPD Sep 29 21:45:34.262293 NOTICE
16.1.0.0
SNMPD Sep 29 21:45:34.263146 NOTICE
All rights reserved.
SYS Sep 29 21:45:36.849457 NOTICE Port 1 up 1000 Full Duplex
SYSLOGD Sep 29 21:45:38.857125 ALERT SYSTEM_READY: The system has finished
booting. (cause was "Warm Reboot")
Copyright (c) 2004 3Com Corporation. All rights reserved.
Username:
P C
ROMPT OMMANDS
Usage — If you use an optional parameter, the parameter setting
overrides the setting of the same parameter in the currently active boot
profile. However, the boot profile itself is not changed. To display the
currently active boot profile, use the display command. To change the
currently active boot profile, use the change command.
Examples — The following command loads system image file
WXA30001.Rel from boot partition 1:
See Also
change on page 673
display on page 678
All rights reserved.
SNMPD: SNMP Agent Resident Module Version
SNMPD: Copyright (c) 2004 3Com Corporation.
All rights reserved.