Telnet - 3Com WX4400 Command Reference Manual

telnet

Examples — To set the time zone for Pacific Standard Time (PST), type
the following command:
WX1200# set timezone PST -8
Timezone is set to 'PST', offset from UTC is -8:0 hours.
See Also
clear summertime on page 139
clear timezone on page 140
display summertime on page 158
display timedate on page 159
display timezone on page 159
set summertime on page 195
set timedate on page 197
Opens a Telnet client session with a remote device.
Syntax — telnet {ip-addr | hostname} [port port-num]
ip-addr — IP address of the remote device.
hostname — Hostname of the remote device.
port port-num — TCP port number on which the TCP server on the
remote device listens for Telnet connections.
Defaults — MSS attempts to establish Telnet connections with TCP port
23 by default.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — To end a Telnet session from the remote device, press Ctrl+t or
type quit or logout in the management session on the remote device. To
end a client session from the local WX switch, use the clear sessions
telnet client command.
If the configuration of the WX switch from which you enter the telnet
command has an ACL that denies Telnet client traffic, the ACL also denies
access by the telnet command.
telnet 199