3Com WX4400 Command Reference Manual page 335

Table 64 Output for display service-profile (continued)
Field
WEP Key 1 value
WEP Key 2 value
WEP Key 3 value
WEP Key 4 value
WEP Unicast Index
WEP Multicast Index
Shared Key Auth
WPA enabled
or
RSN enable
Description
State of static WEP key number 1. Radios can use this key to
encrypt traffic with static Wired-Equivalent Privacy (WEP):
none —T he key is not configured.
preset — The key is configured.
Note: The WEP parameters apply to traffic only on the
encrypted SSID.
State of static WEP key number 2:
none — The key is not configured.
preset — The key is configured.
State of static WEP key number 3:
none — The key is not configured.
preset — The key is configured.
State of static WEP key number 4:
none — The key is not configured.
preset — The key is configured.
Index of the static WEP key used to encrypt unicast traffic on
an encrypted SSID.
Index of the static WEP key used to encrypt multicast traffic
on an encrypted SSID.
Indicates whether shared-key authentication is enabled.
Indicates that the Wi-Fi Protected Access (WPA) information
element (IE) is enabled. Additional fields display the settings
of other WPA parameters:
ciphers — Lists the WPA cipher suites advertised by
radios in the radio profile mapped to this service profile.
authentication — Lists the authentication methods
supported for WPA or RSN clients:
802.1X — dynamic authentication
PSK — preshared key authentication
TKIP countermeasures time — Indicates the amount of
time (in ms) MSS enforces countermeasures following a
second message integrity code (MIC) failure within a
60-second period.
Note: These fields are displayed only when the WPA IE or
RSN IE is enabled.
display service-profile 335