Display Igmp Querier - 3Com WX4400 Command Reference Manual

display igmp
querier
Table 76 Output for display igmp mrouter
Field
Multicast routers for vlan VLAN containing the multicast routers. Ports are
Port
Mrouter-IPaddr
Mrouter-MAC
Type
TTL
See Also
display igmp mrouter on page 470
set igmp mrouter on page 479
Shows information about the active multicast querier, on one VLAN or all
VLANs. Queriers are listed separately for each VLAN. Each VLAN can have
only one querier.
Syntax — display igmp querier [vlan vlan-id]
— VLAN name or number. If you do not specify a
vlan vlan-id
VLAN, MSS displays querier information for all VLANs.
Defaults — None.
Access — Enabled.
Description
listed separately for each VLAN.
Number of the physical port through which the WX
can reach the router.
IP address of the multicast router.
MAC address of the multicast router.
How the WX learned that the port is a multicast
router port:
conf — Static multicast port configured by an
administrator
madv — Multicast advertisement
quer — IGMP query
dvmrp — Distance Vector Multicast Routing
Protocol (DVMRP)
pimv1 — Protocol Independent Multicast (PIM)
version 1
pimv2 — PIM version 2
Number of seconds before this entry ages out if
unused. For static multicast router entries, the TTL
value is undef. Static multicast router entries do not
age out.

display igmp querier

471