Clear Network-Domain - 3Com WX4400 Command Reference Manual

278 C 10: N
HAPTER ETWORK
clear
network-domain
D C
OMAIN OMMANDS
Table 46 Network Domain Commands by Usage (continued)
Type
Clears all Network Domain configuration and information from a WX
switch, regardless of whether the WX switch is a seed or a member of a
Network Domain.
Syntax —

clear network-domain

Defaults — None.
Access — Enabled.
History —Introduced in MSS 4.1.
Examples — This command has no effect if the WX switch is not
configured as part of a Network Domain.
To clear a Network Domain from a WX switch within the domain, type
the following command:
WX1200# clear network-domain
This will clear all network-domain configuration. Would you
like to continue? (y/n) [n] y
success: change accepted.
See Also
set network-domain mode member seed-ip on page 284
set network-domain peer on page 285
set network-domain mode seed domain-name on page 286
Command
clear network-domain peer on page 280
clear network-domain seed-ip on page 281
display network-domain on page 282