Set Radius Server - 3Com WX4400 Command Reference Manual

set radius server

Configures RADIUS servers and their parameters. By default, the WX
switch automatically sets all these values except the password (key).
Syntax —
set radius server
[address ip-address] [auth-port port-number] [acct-port
port-number] [timeout seconds] [retransmit number] [deadtime
minutes] [key string] encrypted-key string] [author-password
password]
— Unique name for this RADIUS server. Enter an
server-name
alphanumeric string of up to 32 characters, with no blanks.
address ip-address
address in dotted decimal notation.
auth-port port-number
authentication and authorization.
acct-port port-numbe
accounting.
timeout seconds
RADIUS server to respond before retransmitting. You can specify from
1 to 65,535 seconds.
retransmit number
before declaring an unresponsive RADIUS server unavailable. You can
specify from 1 to 100 retries.
deadtime minutes
declaring an unresponsive RADIUS server unavailable before retrying
that RADIUS server. Specify between 0 (zero) and 1440 minutes
(24 hours). A zero value causes the switch to identify unresponsive
servers as available.
key string — Password (shared secret key) the WX switch uses to
authenticate to the RADIUS server. You must provide the same
password that is defined on the RADIUS server. The password can be
1 to 64 characters long, with no spaces or tabs.
Use the key option to enter the string in its unencrypted form.
MSS encrypts the displayed form of the string in display config
and display aaa output.
To enter the string in its encrypted form instead, use the
encrypted-key option. MSS does not encrypt the string you enter,
and instead displays the string exactly as you enter it.
server-name
— IP address of the RADIUS server. Enter the
— UDP port that the WX switch uses for
r — UDP port that the WX switch uses for
— Number of seconds the WX switch waits for the
— Number of transmission attempts made
— Number of minutes the WX switch waits after
set radius server 539