Set Snoop Mode - 3Com WX4400 Command Reference Manual

set snoop mode

Enables a snoop filter. A snoop filter does not take effect until you map it
to a MAP radio and enable the filter.
Syntax —
set snoop {filter-name | all}
mode {enable [stop-after num-pkts] | disable}
filter-name | all
all snoop filters.
enable [stop-after num-pkts]
The stop-after option disables the filter after the specified number of
packets match the filter. Without the stop-after option, the filter
operates until you disable it or until the MAP is restarted.
— Disables the snoop filter.
disable
Defaults — Snoop filters are disabled by default.
Access — Enabled.
History —Introduced in MSS Version 4.0.
Usage — The filter mode is not retained if you change the filter
configuration or disable and reenable the radio, or when the MAP or the
WX switch is restarted. You must reenable the filter to place it back into
effect.
Examples — The following command enables snoop filter snoop1, and
configures the filter to stop after 5000 packets match the filter:
WX1200# set snoop snoop1 mode enable stop-after 5000
success: filter 'snoop1' enabled
See Also
display snoop on page 654
display snoop info on page 654
display snoop map on page 655
display snoop stats on page 656
— Name of the snoop filter. Specify all to enable
— Enables the snoop filter.
set snoop mode 653