Clear Spantree Portcost - 3Com WX4400 Command Reference Manual

436 C 12: STP C
HAPTER
clear spantree
portcost
OMMANDS
Table 68 STP Commands by Usage (continued)
Type
Fast
Convergence,
cont.
Statistics
Resets to the default value the cost of a network port or ports on paths to
the STP root bridge in all VLANs on a WX switch.
Syntax — clear spantree portcost port-list
— List of ports. The port cost is reset on the specified ports.
port-list
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — This command resets the cost in all VLANs. To reset the cost for
only specific VLANs, use the clear spantree portvlancost command.
Examples — The following command resets the STP port cost on ports 5
and 6 to the default value:
WX1200# clear spantree portcost 5-6
success: change accepted.
See Also
clear spantree portvlancost on page 437
display spantree on page 440
display spantree portvlancost on page 446
set spantree portcost on page 457
set spantree portvlancost on page 460
Command
set spantree backbonefast on page 454
display spantree backbonefast on
page 443
set spantree uplinkfast on page 462
display spantree uplinkfast on page 452
display spantree statistics on page 446
clear spantree statistics on page 439