Set Snmp Protocol - 3Com WX4400 Command Reference Manual

190 C 7: IP S
HAPTER

set snmp protocol

C
ERVICES OMMANDS
set snmp protocol on page 190
set snmp security on page 191
set snmp usm on page 192
display snmp notify target on page 156
Enables an SNMP protocol. MSS supports SNMPv1, SNMPv2c, and
SNMPv3.
Syntax —
set snmp protocol {v1 | v2c | usm | all} {enable | disable}
v1 — SNMPv1
— SNMPv2c
V2c
— SNMPv3 (with the user security model)
usm
all — Enables all supported versions of SNMP.
enable — Enables the specified SNMP version(s).
disable — Disables the specified SNMP version(s).
Defaults — All SNMP versions are disabled by default.
Access — Enabled.
History —Introduced in MSS Version 4.0.
Usage — SNMP requires the switch's system IP address to be set. SNMP
will not work without the system IP address.
You also must enable the SNMP service using the set ip snmp server
command.
Examples — The following command enables all SNMP versions:
WX1200# set snmp protocol all enable
success: change accepted.
See Also
set ip snmp server on page 173
set snmp community on page 179
set snmp notify target on page 185