Set Mobility-Domain Mode Member Seed-Ip - 3Com WX4400 Command Reference Manual

274 C 9: M
HAPTER OBILITY
set
mobility-domain
mode member
seed-ip
D C
OMAIN OMMANDS
On a nonseed WX switch, sets the IP address of the seed WX switch. This
command is used on a member WX to configure it as a member. If the
WX switch is currently part of another Mobility Domain or using another
seed, this command overwrites that configuration.
Syntax —
set mobility-domain mode member seed-ip ip-addr
— IP address of the Mobility Domain member, in dotted
ip-addr
decimal notation.
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Examples — The following command sets the current WX switch as a
nonseed member of the Mobility Domain whose seed has the IP address
192.168.1.8:
WX4400# set mobility-domain mode member seed-ip 192.168.1.8
mode is: member
seed IP is: 192.168.1.8
See Also
clear mobility-domain on page 270
display mobility-domain config on page 271