Clear Network-Domain Mode - 3Com WX4400 Command Reference Manual

clear
network-domain
mode
Removes the Network Domain seed or member configuration from the
WX switch.
Syntax —
clear network-domain mode {seed | member}
— Clears the Network Domain seed configuration from the WX
seed
switch.
— Clears the Network Domain member configuration from
member
the WX switch.
Defaults — None.
Access — Enabled.
History —Introduced in MSS 4.1.
Usage — This command has no effect if the WX switch is not configured
as part of a Network Domain.
Examples — The following command clears the Network Domain
member configuration from the WX switch:
WX1200# clear network-domain mode member
success: change accepted.
The following command clears the Network Domain seed configuration
from the WX switch:
WX1200# clear network-domain mode seed
success: change accepted.
See Also
set network-domain mode member seed-ip on page 284
set network-domain mode seed domain-name on page 286

clear network-domain mode

279