Display Security Acl Info - 3Com WX4400 Command Reference Manual

display security acl
info
Examples — To display the security ACL hits on a WX switch, type the
following command:
WX4400# display security acl hits
ACL hit-counters
Index Counter
----- -------------------- --------
1
2
3
See Also
set security acl hit-sample-rate on page 511
set security acl on page 504
Displays the contents of a specified security ACL or all security ACLs that
are committed — saved in the running configuration and nonvolatile
storage — or the contents of security ACLs in the edit buffer before they
are committed.
Syntax — display security acl info {acl-name | all]
[editbuffer]
acl-name — Name of an existing security ACL to display. ACL names
must start with a letter and are case-insensitive.
all — Displays the contents of all security ACLs.
editbuffer — Displays the contents of the specified security ACL or
all security ACLs that are stored in the edit buffer after being created
with set security acl. If you do not use this parameter, only
committed ACLs are shown.
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0. The acl-name | all option is no
longer required; display security acl info is valid and displays the same
information as security acl info all in MSS Version 4.1.

display security acl info

ACL-name
0 acl_2
0 acl_175
916 acl_123
497