Set Vlan Tunnel-Affinity - 3Com WX4400 Command Reference Manual

116 C 5: VLAN C
HAPTER OMMANDS
Table 25 describes the fields in this display.
Table 25 Output for display vlan config
Field Description
VLAN VLAN number.
Name VLAN name.
Admin Status Administrative status of the VLAN:
VLAN State Link status of the VLAN:
Tunl Affin Tunnel affinity value assigned to the VLAN.
Port Member port of the VLAN. The port can be a physical port or a
virtual port.
Note: This field can include MAP access ports and wired
authentication ports, because MSS dynamically adds these ports to a
VLAN when handling user traffic for the VLAN.
Tag Tag value assigned to the port.
Port State Link state of the port:
See Also
clear security 12-restrict on page 103
set security l2-restrict on page 118
set vlan port on page 121
set vlan tunnel-affinity on page 122
Down — The VLAN is disabled.
Up — The VLAN is enabled.
Down — The VLAN is not connected.
Up — The VLAN is connected.
Physical ports are 10/100 Ethernet or gigabit Ethernet ports on
the WX switch, and are listed by port number.
Virtual ports are tunnels to other WX switches in a mobility
domain, and are listed as follows: t:ip-addr, where ip-addr is the
system IP address of the WX switch at the other end of the tunnel.
Down — The port is not connected.
Up — The port is connected.