Set System Ip-Address - 3Com WX4400 Command Reference Manual

set system
ip-address
Sets the system IP address so that it can be used by various services in the
WX switch.
CAUTION: Any currently configured Mobility Domain operations cease if
you change the IP address. If you change the address, you must reset the
Mobility Domain.
Syntax —
set system ip-address ip-addr
— IP address, in dotted decimal notation.
ip-addr
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — The following command sets the IP address of the WX
switch to 192.168.253.1:
WX4400# set system ip-address 192.168.253.1
success: change accepted.
See Also
clear system on page 42
set interface on page 164
display system on page 45

set system ip-address

63