Set Spantree Portvlancost - 3Com WX4400 Command Reference Manual

460 C 12: STP C
HAPTER
set spantree
portvlancost
OMMANDS
Changes the cost of a network port or ports on paths to the STP root
bridge for a specific VLAN on a wireless LAN switch.
Syntax —
set spantree portvlancost port-list cost cost {all |
vlan vlan-id}
— List of ports. MSS applies the cost change to all the
port-list
specified ports.
— Numeric value. You can specify a value from 1 through
cost cost
65,535. STP selects lower-cost paths over higher-cost paths.
— Changes the cost on all VLANs.
all
vlan vlan-id
only the specified VLAN.
Defaults — The default port cost depends on the port speed and link
type. (See Table 68 on page 435.)
Access — Enabled.
History —Introduced in MSS Version 3.0.
Examples — The following command changes the cost on ports 3 and 4
to 20 in VLAN mauve:
WX1200# set spantree portvlancost 3,4 cost 20 vlan mauve
success: change accepted.
See Also
clear spantree portcost on page 436
clear spantree portvlancost on page 437
display spantree on page 440
display spantree portvlancost on page 446
set spantree portcost on page 457
— VLAN name or number. MSS changes the cost on