3Com WX4400 Command Reference Manual page 186

186 C 7: IP S
HAPTER ERVICES
C
OMMANDS
[profile profile-name]
[security {unsecured | authenticated | encrypted}]
[retries num]
[timeout num]
— ID for the target. This ID is local to the WX switch and
target-num
does not need to correspond to a value on the target itself. You can
specify a number from 1 to 10.
ip-addr[:udp-port-number]
specify the UDP port number to send notifications to.
— USM username. This option is applicable only when the
username
SNMP version is usm. If the user will send informs rather than traps,
you also must specify the snmp-engine-id of the target.
snmp-engine-id
{ip | hex hex-string}
profile profile-name
to specify the notification types to send or drop.
—
security
{unsecured |
authenticated |
encrypted}
— Specifies the number of times the MSS SNMP engine
retries num
will resend a notification that has not been acknowledged by the
target. You can specify from 0 to 3 retries.
— Specifies the number of seconds MSS waits for
timeout num
acknowledgement of a notification. You can specify from 1 to 5 seconds.
— IP address of the server. You also can
— SNMP engine ID of the target. Specify ip if the
target's SNMP engine ID is based on its
IP address. If the target's SNMP engine ID is a
hexadecimal value, use hex hex-string to
specify the value.
— Notification profile this SNMP user will use
Specifies the security level, and is applicable only
when the SNMP version is usm:
- — Message exchanges are not
unsecured
authenticated, nor are they encrypted. This is
the default.
- authenticated
authenticated, but are not encrypted.
- — Message exchanges are
encrypted
authenticated and encrypted.
— Message exchanges are