Set Service-Profile Cipher-Ccmp - 3Com WX4400 Command Reference Manual

set service-profile
cipher-ccmp
Enables Counter with Cipher Block Chaining Message Authentication
Code Protocol (CCMP) encryption with WPA clients, for a service profile.
Syntax —
set service-profile name cipher-ccmp
{enable | disable}
— Service profile name.
name
— Enables CCMP encryption for WPA clients.
enable
— Disables CCMP encryption for WPA clients.
disable
Defaults — CCMP encryption is disabled by default.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — To use CCMP, you must also enable the WPA IE.
Examples — The following command configures service profile sp2 to
use CCMP encryption:
WX4400# set service-profile sp2 cipher-ccmp enable
success: change accepted.
See Also
display service-profile on page 330
set service-profile cipher-tkip on page 400
set service-profile cipher-wep104 on page 402
set service-profile cipher-wep40 on page 401
set service-profile wpa-ie on page 433

set service-profile cipher-ccmp

399