Clear Ip Telnet; Clear Ntp Server - 3Com WX4400 Command Reference Manual

clear ip telnet

clear ntp server

Resets the Telnet server's TCP port number to its default value. A WX
switch listens for Telnet management traffic on the Telnet server port.
Syntax —
clear ip telnet
Defaults — The default Telnet port number is 23.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — The following command resets the TCP port number for
Telnet management traffic to its default:
WX4400# clear ip telnet
success: change accepted.
See Also
display ip https on page 149
display ip telnet on page 152
set ip https server on page 171
set ip telnet on page 175
set ip telnet server on page 176
Removes an NTP server from a WX switch configuration.
Syntax —
clear ntp server {ip-addr | all}
— IP address of the server to remove, in dotted decimal
ip-addr
notation.
— Removes all NTP servers from the configuration.
all
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
clear ip telnet 135