3Com WX4400 Command Reference Manual page 189

community-string
profile profile-name
to specify the notification types to send or drop.
Defaults — The default UDP port number on the target is 162. The
default minimum required security level is unsecured. The default
number of retries is 0 and the default timeout is 2 seconds.
Access — Enabled.
History — Introduced in MSS Version 4.0.
Usage — The inform or trap option specifies whether the MSS SNMP
engine expects the target to acknowledge notifications sent to the target
by the WX switch. Use inform if you want acknowledgements. Use trap
if you do not want acknowledgements. The inform option is applicable
to SNMP version v2c or usm only.
Examples — The following command configures a notification target for
acknowledged notifications:
WX1200# set snmp notify target 1 10.10.40.9 usm inform user
securesnmpmgr1 snmp-engine-id ip
success: change accepted.
This command configures target 1 at IP address 10.10.40.9. The target's
SNMP engine ID is based on its address. The MSS SNMP engine will send
notifications based on the default profile, and will require the target to
acknowledge receiving them.
The following command configures a notification target for
unacknowledged notifications:
WX1200# set snmp notify target 2 10.10.40.10 v1 trap
success: change accepted.
See Also
clear snmp notify target on page 138
set ip snmp server on page 173
set snmp community on page 179
set snmp notify profile on page 181
— Community string.
— Notification profile this SNMP user will use
set snmp notify target 189