Set Dap Boot-Ip - 3Com WX4400 Command Reference Manual

346 C 11: M
HAPTER

set dap boot-ip

A P C
ANAGED CCESS OINT OMMANDS
Usage — Changing the LED blink mode does not alter operation of the
MAP access point. Only the behavior of the LEDs is affected.
Examples — The following command enables LED blink mode on the
MAP access points connected to ports 3 and 4:
WX1200# set ap 3-4 blink enable
success: change accepted.
Specifies static IP address information for a Distributed MAP.
Syntax — set dap dap-num boot-ip ip ip-addr netmask mask-addr
gateway gateway-addr
Syntax — set dap dap-num boot-ip mode {enable | disable}
dap dap-num
specifying static IP information.
ip ip-addr
decimal notation (for example, 10.10.10.10).
netmask mask-addr
(for example, 255.255.255.0).
gateway gateway-addr
dotted decimal notation.
{
mode enable
for the MAP.
Defaults — By default MAPs use DHCP to obtain an IP address, rather
than a using a manually assigned IP address.
Access — Enabled.
History —Introduced in MSS 4.2.
History —Normally, Distributed MAPs use DHCP to obtain IP address
information. In some installations, DHCP may not be available. In this
case, you can assign static IP address information to the MAP, including
the MAP's IP address and netmask, and default gateway.
If the manually assigned IP information is incorrect, the MAP uses DHCP
to obtain its IP address.
[ {
mode enable
— Number of the Distributed MAP for which you are
— The IP address to be assigned to the MAP, in dotted
— The subnet mask, in dotted decimal notation
— The IP address of the next-hop router, in
| } — Enables or disables the static IP address
disable
| }]
disable