Display Port Status - 3Com WX4400 Command Reference Manual

display port status

Table 12 Output for display port poe (continued)
Field
Link status
Port type
PoE config
PoE Draw
See Also
set port poe on page 92
Displays configuration and status information for ports.
Syntax — display port status [port-list]
port-list — List of physical ports. If you do not specify a port list,
information is displayed for all ports.
Defaults — None.
Access — All.
History — Introduced in MSS Version 3.0.
Description
Link status of the port:
up—The port is connected.
down—The port is not connected.
Port type:
MAP —The port is a MAP access port.
- (The port is not a MAP access port.)
PoE state:
enabled
disabled
Power draw on the port, in watts.
For 10/100 Ethernet ports on which PoE is disabled,
this field displays off. For gigabit Ethernet ports, this
field displays invalid, because PoE is not supported
on gigabit Ethernet ports.
The value overcurrent indicates a PoE problem such
as a short in the cable.
display port status 77