3Com WX4400 Command Reference Manual page 328

328 C 11: M
HAPTER ANAGED
A P C
CCESS OINT OMMANDS
Table 63 describes the fields in this display.
Table 63 Output for display radio-profile
Field
Beacon Interval
DTIM Interval
Max Tx Lifetime
Max Rx Lifetime
RTS Threshold
Frag Threshold
Long Preamble
Tune Channel
Tune Power
Tune Channel
Interval
Tune Power Interval
Description
Rate (in milliseconds) at which each MAP radio in the profile
advertises the beaconed SSID.
Number of times after every beacon that each MAP radio in
the radio profile sends a delivery traffic indication map
(DTIM).
Number of milliseconds that a frame received by a radio in
the radio profile can remain in buffer memory.
Number of milliseconds that a frame scheduled to be
transmitted by a radio in the radio profile can remain in
buffer memory.
Minimum length (in bytes) a frame can be for a radio in the
radio profile to use the RTS/CTS method to send the frame.
The RTS/CTS method clears the air of other traffic to avoid
corruption of the frame due to a collision with another
frame.
Maximum length (in bytes) a frame is allowed to be without
being fragmented into multiple frames before transmission
by a radio in the radio profile.
Indicates whether an 802.11b radio that uses this radio
profile advertises support for frames with long preambles
only:
YES — Advertises support for long preambles only.
NO — Advertises support for long and short preambles.
Indicates whether RF Auto-Tuning is enabled for dynamically
setting and tuning channels.
Indicates whether RF Auto-Tuning is enabled for dynamically
setting and tuning power levels.
Interval, in seconds, at which RF Auto-Tuning decides
whether to change the channels on radios in a radio profile.
At the end of each interval, MSS processes the results of the
RF scans performed during the previous interval, and
changes radio channels if needed.
Interval, in seconds, at which RF Auto-Tuning decides
whether to change the power level on radios in a radio
profile. At the end of each interval, MSS processes the results
of the RF scans performed during the previous interval, and
changes radio power levels if needed.