Set {Ap | Dap} Bias - 3Com WX4400 Command Reference Manual

set {ap | dap} bias

History —Introduced in MSS 4.0.
Usage — You must use the set dap auto command to create the profile
before you can enable it.
Examples — The following command enables the profile for automatic
Distributed MAP configuration:
WX4400# set dap auto mode enable
success: change accepted.
See Also
set dap auto on page 339
set dap auto persistent on page 341
set dap auto radiotype on page 342
set {ap | dap} bias on page 343
set {ap | dap} blink on page 345
set {ap | dap} group on page 351
set {ap | dap} radio auto-tune max-power on page 354
set {ap | dap} radio auto-tune max- retransmissions on page 356
set {ap | dap} radio auto-tune min-client-rate on page 359
set {ap | dap} radio mode on page 360
set {ap | dap} radio radio-profile on page 362
set {ap | dap} upgrade-firmware on page 365
Changes the bias for a MAP. Bias is the priority of one WX switch over
other WX switches for booting and configuring the MAP.
Syntax — set {ap port-list | dap dap-num | auto} bias {high
| low}
ap port-list — List of ports on which to change the bias for directly
connected MAPs.
— Number of a Distributed MAP for which to change
dap dap-num
the bias.
set {ap | dap} bias 343