3Com WX4400 Command Reference Manual page 294

294 C 11: M
HAPTER ANAGED
A P C
CCESS OINT OMMANDS
max-rx-lifetime
max-tx-lifetime
preamble-length
rts-threshold
service-profile
For information about these parameters, see the set radio-profile
commands that use them.
Defaults — If you reset an individual parameter, the parameter is
returned to the default value listed in Table 66 on page 380.
Access — Enabled.
History —Introduced in MSS Version 3.0. countermeasure parameter
added in Version 4.1. Version 4.2 removes the long-retry and
short-retry parameters that no longer apply to radio profiles .
Usage — If you specify a parameter, the setting for the parameter is
reset to its default value. The settings of the other parameters are
unchanged and the radio profile remains in the configuration. If you do
not specify a parameter, the entire radio profile is deleted from the
configuration. All radios that use this profile must be disabled before you
can delete the profile.
Examples — The following commands disable the radios that are using
radio profile rp1 and reset the beaconed-interval parameter to its
default value:
WX4400# set radio-profile rp1 mode disable
WX4400# clear radio-profile rp1 beacon-interval
success: change accepted.
The following commands disable the radios that are using radio profile
rptest and remove the profile:
WX4400# set radio-profile rptest mode disable
WX4400# clear radio-profile rptest
success: change accepted.
See Also
display radio-profile on page 327
set {ap | dap} radio radio-profile on page 362