Set Radio-Profile Dtim-Interval - 3Com WX4400 Command Reference Manual

set radio-profile
dtim-interval
The following command disables countermeasures in radio profile
radprof3:
WX1200# clear radio-profile radprof3 countermeasures
success: change accepted.
The following command causes radios managed by radio profile radprof3
to issue countermeasures against devices in the WX switch's attack list:
WX1200# set radio-profile radprof3 countermeasures configured
success: change accepted.
Note that when you issue this command, countermeasures are then
issued only against devices in the WX switch's attack list, not against
other devices that were classified as rogues by other means.
See Also
display radio-profile on page 327
Changes the number of times after every beacon that each MAP radio in
a radio profile sends a delivery traffic indication map (DTIM). A MAP
access point sends the multicast and broadcast frames stored in its
buffers to clients who request them in response to the DTIM.
The DTIM interval applies to both the beaconed SSID and the
nonbeaconed SSID.
Syntax — set radio-profile name dtim-interval interval
name — Radio profile name.
interval — Number of times the DTIM is transmitted after every
beacon. You can enter a value from 1 through 31.
Defaults — By default, MAP access points send the DTIM once after
each beacon.
Access — Enabled.
History —Introduced in MSS Version 3.0.

set radio-profile dtim-interval

375