3Com WX4400 Command Reference Manual page 326

326 C 11: M
HAPTER ANAGED
A P C
CCESS OINT OMMANDS
If a Distributed MAP is configured on a WX switch in another Mobility
Domain, the MAP can appear in the output until the MAP is able to
establish a connection with a WX switch in its Mobility Domain. After the
MAP establishes a connection, the entry for the MAP ages out and no
longer appears in the command's output.
Entries in the command output's table age out after two minutes.
Examples — The following command displays information for two
Distributed MAPs that are not configured:
WX1200# display dap unconfigured
Total number of entries: 2
Serial Id Model
------------- ------ --------------- ---- --------
M9DE48B012F00 AP2750 10.3.8.54
M9DE48B123400 AP2750 10.3.8.57
Table 62 describes the fields in this display.
Table 62 Output for display dap unconfigured
Field
Serial Id
Model
IP Address
Port
VLAN
See Also
display dap connection on page 322
display dap global on page 324
IP Address
Description
Serial ID of the Distributed MAP.
MAP model number.
IP address of the MAP. This is the address that the MAP
receives from a DHCP server. The MAP uses this address to
send a Find WX message to request configuration
information from WX switches. However, the MAP cannot
use the address to establish a connection unless the MAP
first receives a configuration from a WX switch.
Port number on which this WX switch received the MAP's
Find WX message.
VLAN on which this WX switch received the MAP's Find
WX message.
Port Vlan
5 default
6 vlan-eng