Clear {Ap | Dap} Radio - 3Com WX4400 Command Reference Manual

clear {ap | dap}
radio
Disables a MAP radio and resets it to its factory default settings.
Syntax —
clear {ap port-list | dap dap-num } radio {1 | 2 | all}
— List of ports connected to the MAP access point(s) on
ap port-list
which to reset a radio.
— Number of a Distributed MAP on which to reset a radio.
dap dap-num
— Radio 1 of the MAP.
radio 1
— Radio 2 of the MAP. (This option does not apply to
radio 2
single-radio models.)
radio all — All radios on the MAP.
Defaults — The clear ap radio command resets the radio to the default
settings listed in Table 49 and in Table 66 on page 380.
Table 49 Radio-Specific Parameters
Parameter
antennatype
auto-tune
Default Value
For most MAP models, the
default is internal.
For MP-620, the default
for the 802.11b/g radio is
ANT-1360-OUT. The
default for the 802.11a
radio is ANT-5360 OUT.
The default for the
802.11b/g radio on model
MP-262 is ANT1060.
max-power—highest
setting allowed for the
country of operation or
highest setting
supported on the
hardware, whichever is
lower
max-retransmissions—
10 percent
min-client-rate—5.5 Mb
ps for 802.11b/g;
24 Mbps for 802.11b/g

clear {ap | dap} radio

Description
External antenna model
Note: This parameter is
configurable only on MAPs
that support external
antennas.
RF Auto-Tuning settings:
max-power—maximum
power that RF Auto-Tuning
can set on a radio
max-retransmissions—ma
ximum percentage of
client retransmissions a
radio can experience
before RF Auto-Tuning
considers changing the
channel on the radio
min-client-rate—minimum
rate at which a radio is
allowed to transmit traffic
to clients
291