Set Radius Client System-Ip - 3Com WX4400 Command Reference Manual

536 C 16: RADIUS
HAPTER
set radius client
system-ip
S G C
AND ERVER ROUP OMMANDS
See Also
clear radius server on page 533
display aaa on page 223
set radius server on page 539
Causes all RADIUS requests to be sourced from the IP address specified by
the set system ip-address command, providing a permanent source IP
address for RADIUS packets sent from the WX switch.
Syntax —

set radius client system-ip

Defaults — None. If you do not use this command, RADIUS packets
leaving the WX have the source IP address of the outbound interface,
which can change as routing conditions change.
Examples — Enabled.
History —Introduced in MSS Version 3.0.
Usage — The WX system IP address must be set before you use this
command.
Examples — The following command sets the WX system IP address as
the address of the RADIUS client:
WX4400# set radius client system-ip
success: change accepted.
See Also
clear radius client system-ip on page 531
set system idle-timeout on page 62