Set {Ap | Dap} Group - 3Com WX4400 Command Reference Manual

set {ap | dap} group

See Also
set dap security on page 364
set service-profile cipher-wep40 on page 401 on page 433
display {ap | dap} status on page 310
Configures a named group of MAP access points. MSS automatically load
balances sessions among the access points in a group. To balance the
sessions, MSS rejects an association request for an access point's radio if
that radio has at least four more active sessions than the radio of the
same type with the least number of active sessions within the group.
Syntax —
set {ap port-list | dap dap-num | auto} group name
ap port-list — List of MAP access ports to add to the group.
dap dap-num — Number of a Distributed MAP to add to the group.
— Configures a MAP group for the MAP configuration
dap auto
profile. (See set dap auto on page 339.)
name — MAP access point group name of up to 16 alphanumeric
characters, with no spaces.
Defaults — MAP access points are not grouped by default.
Access — Enabled.
History —Introduced in MSS Version 3.0. Option auto added for
configuration of the MAP configuration profile.
Usage — You can assign any subset or all of the MAP access points
connected to an WX switch to a group on that switch. All access points in
a group must be connected to the same WX switch.
If you use the name none, spelled in any combination of capital or
lowercase letters, the specified MAP access point is cleared from all MAP
access point groups.
set {ap | dap} group 351