Set Service-Profile Wep Active-Multicast-Index - 3Com WX4400 Command Reference Manual

430 C 11: M
HAPTER
set service-profile
wep
active-multicast-
index
A P C
ANAGED CCESS OINT OMMANDS
See Also
display service-profile on page 330
set service-profile user-idle-timeout on page 426
Specifies the static Wired-Equivalent Privacy (WEP) key (one of four) to
use for encrypting multicast frames.
Syntax —
set service-profile
name wep active-multicast-index num
— Service profile name.
name
— WEP key number. You can enter a value from 1 through 4.
num
Defaults — If WEP encryption is enabled and WEP keys are defined,
MAP radios use WEP key 1 to encrypt multicast frames, by default.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — Before using this command, you must configure values for the
WEP keys you plan to use. Use the set service-profile wep key-index
command.
Examples — The following command configures service profile sp2 to
use WEP key 2 for encrypting multicast traffic:
WX4400# set service-profile sp2 wep active-multicast-index 2
success: change accepted.
See Also
display service-profile on page 330
set service-profile wep active-unicast- index on page 431
set service-profile wep key-index on page 432